Counting starts with the bedrooms. Queensland's rule puts an alarm in each bedroom; then, on each storey that has bedrooms, one in the hallway connecting them to the rest of the home, or between the bedrooms and the rest of the storey where there is no hallway; and on any storey without bedrooms, one on the most likely path to an exit. Every alarm must be photoelectric, comply with AS 3786-2014, contain no ionisation sensor, and be interconnected so that when one sounds they all do. In a single-level four-bedroom house that means at least the bedrooms plus the hallway; a second storey or a split bedroom wing adds more. Where each one sits on the ceiling is set too, at least 300mm from lights and corners and 400mm from air conditioner outlets and ceiling fan blades.
That count is worth doing yourself first. The Queensland Fire Department warns that some traders sell non-compliant alarms or overstate the number of alarms the law requires, and advises double-checking what agents and body corporate managers say. Tom's own guide describes the same starting point: walking the home, counting every bedroom and room that could be slept in, and mapping each level and its hallways.
The next question is power. Ferny Grove's urbanisation came in the late 1970s, so many of its houses likely went up before hardwired alarms became compulsory for new Queensland homes on 1 July 1997. From 1 July 2007 every home needed at least a battery alarm, so older houses may have started with battery units. If an existing alarm is hardwired, its replacement must be hardwired too, and 240V work needs a licensed electrician. Any other alarm, whether new or replacing a battery unit, may instead run on a built-in battery made to last at least 10 years, and an existing home can mix 240V and battery alarms on wired or wireless interconnection. Hardwiring into an older house whose power points have no safety switch may bring one into the job.
Age counts as well. Any alarm must be replaced within 10 years of its manufacture date, and a new one must be less than 10 years old when fitted, so alarms added in earlier upgrades may already be due. After connecting electrical work, the contractor must give a certificate of testing and compliance.